Thick Repair Mortar
PRODUCT DESCRIPTION: A cement-based practical surface repair mortar used for repairing peeled, cracked surfaces or surfaces beyond-use date, and plaster deformations. Used on non-structural surfaces. APPLICATION AREA: Used for repairing plaster cracks, renovation and overhaul applications in interior and exterior areas. With high bond strength. Easy to use. The product may change depending on changing dimension of overhaul and crack. ≤ 2 mm – Micro Crack, ≥ 2 mm – 5 mm – Hair Crack ≥ 5 mm – 15 mm – Coarse Crack APPLICATION INSTRUCTION PRELIMINARY PREPARATION: Check beforehand the firmness, water absorption and solidity of the surface where the product will be applied on. Use Asvil Water Isolation additive to eliminate water absorption if the water absorption of the surface is high. Repair the defects and voids on the surface needing overhaul beforehand. Ensure that the surface to be covered is clean and free from dust, dirt, residues, grease and any other contamination. MIXTURE AND APPLICATION: Pour 6-7 liters of water into the mixture container and slowly add mortar over the water until a homogenous and consistent paste is obtained. Use a low speed mixer for mixing. Using a high speed mixer may inhibit obtaining a consistent paste. Wait 5 minutes for maturation and mix the mortar again for 1 minute; the mortar is ready to use. Apply the mortar on to the surface by a steel trowel. If plastering will not be applied, apply the mortar in 0.5 cm thickness on monolayer, after dampening of the surface to be repaired. Wait 3-4 hours depending on the ambient conditions for application of next layer. The thickness of the 2nd layer should be the same with the first. Never exceed 1 cm thickness of application on the surface to be repaired. Apply the mortar by a brush in case the crack size is less than 2 mm. The tools and equipments should be washed with plenty of water immediately after use. Never include water inside the expired material to reuse it. Hardened material in the container with completion of setting is unusable. WARNINGS AND PRECAUTIONS: – Avoid application under temperature limits below +5°C and over +35°C. – Ensure that the application surface is clean and free from dust, dirt, residues, grease and any other contamination. – Mix the material by maximum 120 RPM mixer. – Consume the prepared mortar within 2 hours of mixing. – Do not absolutely make any inclusion (such as lime, sand, cement) other than water. – Avoid making further application on to the surface until completion of its setting and protect the surface from water. – Protect the surface from external factors (wind, wet and sunlight) during the application. – The shelf life is preserved in unopened package in proper storing medium.