Heat Insulation Board Adhesive
Thermal Insulating Board Adhesive cement-based, heavy-duty high performance adhesive containing chemical additives and modified polymer and used for fixing Thermal Insulating Boards. APPLICATION AREA: Used for fixing of all kinds of thermal insulating boards applied on interior and exterior walls. APPLICATION INSTRUCTIONS PRELIMINARY PREPARATION: Check beforehand the firmness, water absorption and solidity of the surface where the product will be applied on. Repair the defects and voids on the surface needing overhaul beforehand. Ensure that the surface to be covered is clean and free from dust, dirt, residues, grease and any other contamination. MIXTURE AND APPLICATION: Pour 6-7 liters of water into the mixture container and slowly add powder fraction over the water until a homogenous and consistent paste is obtained. Use a low speed mixer for mixing. Using a high speed mixer may inhibit obtaining a consistent paste. Wait 5 minutes for maturation and mix the mortar again; the mortar is ready to use. The tools and equipments should be washed with plenty of water immediately after use. Never attempt to make bonding on the expired material which should be cleaned from the surface. Hardened material in the container with completion of setting is unusable. APPLICATION: The prepared mixture is applied in two ways depending on whether or not the surface where the board will be applied is set by a floating rule. If the surface is leveled and trimmed, spread the mortar behind the board fully by dredging. If there is disorder on the surface where sheathing is applied or the surface is not leveled, apply the mortar on 4 corners of the board by the method of heaping and apply 3-group of heaps at the center. The plastering can be started after minimum 24-36 hours after bonding, depending on the weather conditions. Apply the adhesive on minimum % 40-45 percent of the rear side of the thermal insulating board. Bed the boards firmly into the adhesive with a slight sliding action to ensure a good contact and bonding of thermal insulating board with the wall and ensure that the flatness is obtained by tamping by float. Install the boards by breaking joint method starting from the base. Using split and undivided boards on the corners will prevent alignment of all boards. The thickness of the board used, flatness of the surface and selection of expansion bolt depending on application method are important factors. For one board, use 6 expansion bolts: 4 pieces on the corners where the boards join and 2 pieces at the center. The number of expansion bolts can be increased depending on application height and the state of the wall of building. WARNINGS AND PRECAUTIONS: – Avoid application under temperatures below + 5°C and over + 35°C. – Ensure that the application surface is clean and free from dust, dirt, residues, grease and any other contamination. – Mix the material by maximum 120 RPM mixer. – Consume the prepared mortar in 2 hours of mixing. – Do not absolutely make any inclusion (such as lime, sand, cement) other than water. – Store in maximum 8 stacks. Store in dry and damp free medium, inside unopened package. – More resistant to external factors (rain, sunlight, wind, etc.) than older plasters. – Avoid the surface from external factors (rain, sunlight, wind, etc.). – Avoid direct breathing of its powder and skin contact due to its cement based content. – Wear protective clothes during operation. – Technical Values are obtained in laboratory environment.