Machine Plaster Mortar
APPLICATION AREA: Used for plastering surfaces of interior and exterior brick, gas concrete, concrete, exposed concrete, briquette walls and ceilings. SPECIFICATIONS: Offers brown coat and finish plastering in composite by mono layer application. Creates a solid ground by high adhesion and wear strength. Offers easy and quick applicability by machinery. Creates higher water resistance compared to traditional plasters. APPLICATION: PREPARING SURFACE: Ensure that the application surface is absolutely clean and free from form oil, dust, paint and agents reducing the bond strength. Repair the defects and voids on the surface needing overhaul beforehand by the same material or a proper Asvil repair mortars. Dampen the application surface if necessary. Treat the surface by pre-sprinkling 1 day before application. Make application immediately after drying of the surface. MORTAR PREPARATION AND APPLICATION METHOD: Spray the Asvil readymade plaster to the surface by mixing by a mixer or by a spraying machine (9-10 liters of water per 50 kg of material). The application thickness in mono layer should be between 1cm and 2.5 cm. If the thickness is more than 2.5 cm, then the second layer must be applied maximum 2.5 cm, after completion of setting of first layer. Make finish on the surface by a floating rule. After adequate hardening of the surface, smooth the plastered surface by a float and wipe it by a wet sponge. WARNINGS – Do not make any inclusion (lime, cement, gypsum, etc.) into prepared mortar. – Advised application temperature is around +5°C, +35°C. – Asvil should be prevented from quick drying in case of windy weathers. – Plaster mesh is advised where the different materials merge and where moving action may occur. – Wait minimum 10 days, depending on ambient temperature, for further applications over Asvil – Dampen the surface at certain time intervals during 3 day period after application to increase the strength of product. – Do not go beyond the specified application surface and follow the using instruction. – Avoid direct breathing of its powder. Wash immediately with plenty of water in case of eye contact and consult a physician, if required.