Expert 25 Monocotto 25kg
APPLICATION AREA: Used for plastering surfaces of interior and exterior brick, gas concrete, concrete, exposed concrete, briquette walls and ceilings. SPECIFICATIONS: Offers brown coat and finish plastering in composite by mono layer application. Offers easy and quick applicability. Creates a solid ground by high adhesion property and wear strength. APPLICATION: PREPARING SURFACE: Ensure that the application surface is absolutely clean and free from form oil, dust, paint and agents reducing the bond strength. Repair the defects and voids on the surface needing overhaul beforehand by the same material or a proper Asvil repair mortars. Dampen the application surface if necessary. Treat the surface by pre-sprinkling 1 day before application. Make application immediately after drying of the surface. MORTAR PREPARATION AND APPLICATION METHOD: Asvil readymade plaster is prepared by a mixer or by mixing by hand (add 10.5 - 11.5 liters of water per 50 kg of material) The application thickness in mono layer should be between 1cm and 2.5 cm. If the thickness is more than 2.5 cm, then the second layer must be applied maximum 2.5 cm, after completion of setting of first layer. The prepared mortar is applied and floated by mortar board or trowel. After that process, the plaster surface is treated by float and wiped by a wet sponge. WARNINGS: – Do not make any inclusion (lime, cement, gypsum, etc.) into prepared mortar. – Advised application temperature is between +5°C, +35°C. – Avoid quick drying of Asvil in case of windy weathers. – Dampen the surface at certain time intervals during 3 day period after application to increase the strength of product. – Double-layered application is advised particularly during summer time operation for the purpose of preventing cracks because of quick drying. – Plaster mesh is advised where the different materi - als merge and where moving action may occur. – Wait minimum 10 days, depending on ambient temperature, for further applications over Asvil. – Do not go beyond the specified application surface and follow the using instruction. – Avoid direct breathing of its powder. Wash immedi - ately with plenty of water in case of eye contact and consult a physician, if required. – Ask for product safety flyer for further information. – Get into contact with us for further questions regarding all further application conditions and technical matters
